FM RDS Broadcaster & RF Jammer

Name

Muhammad AhsanID

F2019376007

“Broadcast own signals with raspberry and jamming these signals”

Broadcast own signals with raspberry and jamming these signals

IN this project we first do broadcasting our own signals using raspberry

First we install PiFmAdv in our raspberry

After that we use this command to broadcast signal on empty place where no signals before we get a place at

434.000.000

“sudo ./pi_fm_rds -freq 434.000 -audio sound.wav”

Then our signal is broadcosting which we see in below figure

After broadcasting signals now we are going to jamm these Signals or doing distortion in signals

NOW we are going to jamm these signal .

First we install gr-osmosdr software for gamming signals

For installing this software we just type this command

Run this software just using this command

It runs in gui form

Now set frequency which we jamm

Now we can use this software in many ways,

We can make disturbances in signals in many ways

You see a little distortion in signals

There are many methods to jamm signal in this software.

“So you see all distortion of signals in up pictures so that’s all our project is first we broadcast signals with raspberry and then we jamm these signals.”

The

End